287
AXLES
SUSPENSION
STEERING
WARNING : The values shown should only be used as guides. In case of doubt, check the settings at reference height (See page 286)
Measurements at reference height (continued)
NOTE : To make the setting of reference height easier, it is acceptable to take the measurement from the flange of the jacking point.
Front height Rear height
H1’ = Measurement from the jacking point.
L1’ = R1 – H1’
L2 = R2 – H2
Compress the suspension to obtain the calculated values.
1.6i – 1.8i 16 V – 2.0 HDiEngines
90.5 mmL1
124 mmL1’
AXLE GEOMETRY
XSARA PICASSO - All Types
B3CP058D
B3DP079C
B3CP05BC
To Next Page
Loading...
