CITROEN Jumpy 2020 - Page 126

124
Ease of use and comfort
Jumpy_en_Chap03_ergonomie-et-confort_ed01-2016
Fit the net
Unclip the upper fixing covers and secure the
lower fixings (as previously described).
F Fold (table position) the seats and bench
seats in rows 2 and 3 (according to
equipment).
F
Unroll the high load retaining net.
F
Position the upper net fixings in the
corresponding anchorages in the roof
(first one side, then the other).
F
Fully extend the straps.
F
On each side, attach the bottom fixings of
the net to the lower anchorages (behind
row 1) or in the stowing rings (behind
row
2).
F
Pull on the straps to stretch the net.
F
Check that the net is attached securely and
properly extended.
Never use the ISOFIX ring intended
for fixing the upper strap of a child seat
with Top Tether.
If fitted to your vehicle, the side windows in row
2 can be opened.
Windows in row 2
For more information on the Child
lock for rear windows, refer to the
corresponding section.
While driving, the window must be closed or
secured at one of the notches.
F Squeeze the two controls then move the
window sideways.
F On each side in row 2, insert the fixings in the
floor anchorages then turn them a quarter turn
to lock them in place (as shown above).
Place them as close as possible to the end of
the rail.
If your vehicle has seats and bench seats or
individual seats on rails:
Lower xings
(behind row 2)
F Use the stowing rings.