316
In the event of a breakdown
Jumpy_en_Chap08_En-cas-de-panne_ed01-2016
F
Unclip the cover by pulling at the top left, then
right.
F
Disengage the cover completely and turn it over,
Good Failed
Tweezer
Access to the tools
F Take the tweezer from its housing.
The extraction tweezer is located behind the
fusebox cover, on the dashboard pillar.
Before changing a fuse:
F the cause of the failure must be identified
and rectified,
F all electrical consumers must be
switched
off,
F
the vehicle must be immobilised with the
ignition off,
F identify the failed fuse using the tables and
layout drawings in the following pages.
Changing a fuse
To replace a fuse, you must:
F
use the special tweezer to extract the fuse
from its housing and check the condition of
its filament.
F
always replace the failed fuse with a fuse
of the same rating (same colour); using
a different rating could cause faults (risk
of
fire).
If the fuse fails again soon after replacement,
have the vehicle's electrical system checked by
a CITROËN dealer or a qualified workshop.
The replacement of a fuse not shown in
the tables below may cause a serious
malfunction of your vehicle. Contact
a CITROËN dealer or a qualified
workshop.
Changing a fuse
To Next Page
Loading...
