186
Safety
Jumpy_en_Chap05_securite_ed01-2016
"ISOFIX" mountings
The incorrect installation of a child seat
in a vehicle compromises the child's
protection in the event of an accident.
For information on the possibilities for
installing ISOFIX child seats in your
vehicle, refer to the locations table.
Observe strictly the fitting instructions
provided with the child seat.
Your vehicle has been approved to the latest
ISOFIX regulation.
If fitted on your vehicle, the regulation ISOFIX
mountings are located by labels.
The mountings comprise three rings for each
seat:
- Two front rings A, located between
the vehicle seat backrest and cushion,
indicated by an "ISOFIX" marking,
-
If fitted to your vehicle, a rear ring B,
located behind the vehicle's seat, called
the Top Tether, for securing the upper
strap, indicated by a "Top Tether" marking.
The Top Tether is used to secure the upper
strap of child seats that have one. In the event
of a front impact, this system limits the forward
tipping of the child seat.
This ISOFIX mounting system provides fast,
reliable and safe fitting of the child seat in your
vehicle.
The ISOFIX child seats are fitted with two
latches which are secured on the two front
rings A.
Some also have an upper strap which is
attached to the rear ring B.
To secure the child seat to the Top Tether:
-
remove and stow the head restraint before
installing a child seat on this seat (refit it
once the child seat has been removed),
-
pass the child seat upper strap over the
top of the seat backrest, between the
apertures for the head restraint rods,
-
fix the hook on the end of the upper strap
to the rear ring B,
- tighten the upper strap.
To Next Page
Loading...
