75
2
Access
Jumpy_en_Chap02_ouvertures_ed01-2016
Closing
F Push or pull the door to close it, then
lock
it.
For more information on the Key,
Remote control or Keyless Entry
and Starting and in particular locking
the vehicle, refer to the corresponding
section.
When a door is not fully closed:
- vehicle stationary and engine
running, this warning lamp
comes on, accompanied by an
alert message for a few seconds,
- vehicle moving (speed above
6 mph (10 km/h)), this warning
lamp comes on, accompanied
by an audible signal and an alert
message for a few seconds.
Manual sliding side door(s)
From outside
F After unlocking the vehicle (using the
key, remote control or Keyless Entry and
Starting, depending on equipment) pull the
door handle.
Take care not to block the guide space
on the floor to allow the door to slide
correctly.
As a safety measure and for functional
reasons, do not drive with the sliding
side door open.
For more information on the Key,
Remote control or Keyless Entry and
Starting and in particular unlocking
the vehicle, refer to the corresponding
section.
To hold the sliding side door in the open
position, open the door fully to engage
the latch (located at the bottom of the
door).
To Next Page
Loading...
