204
Driving
Jumpy_en_Chap06_conduite_ed01-2016
Back-up starting
Should your vehicle not detect the electronic
key in the recognition zone, because the
remote control battery is flat, a back-up reader
is provided to the left, behind the steering
wheel to allow starting.
F
Press the "START/STOP" button.
The engine starts.
If the remote control is no longer in the
recognition zone when you close a door or
when you (later) request switching off the
engine, a message appears in the instrument
panel.
Forced switch-off
Remote control not
recognised
F If you want to force switching off the
engine, press and hold the "START/STOP"
button for about 3 seconds, then contact a
CITROËN dealer or a qualified workshop.
F
If your vehicle has a manual gearbox, place
the gear lever in neutral then fully depress
the clutch pedal.
F If your vehicle has an automatic gearbox,
place the selector at position P then press
the brake pedal firmly.
F
If your vehicle has an electronic gearbox,
place the selector at position N then press
the brake pedal firmly.
In the event of an emergency only and with the
vehicle stationary, you can switch off the engine.
To do this, press and hold the "START/STOP"
button for about 3 seconds.
In this case the steering column locks as soon
as the vehicle stops.
F Place and hold the remote control against
the reader, then:
To Next Page
Loading...
