221
6
Driving
Jumpy_en_Chap06_conduite_ed01-2016
Operating fault
Depending on your vehicle's equipment:
Have it checked by a CITROËN dealer or a
qualified workshop.
In the event of a fault in STOP mode, the
vehicle may stall.
All of the instrument panel warning lamps
come
on.
Depending on version, an alert message may
also be displayed, asking you to place the gear
lever in position N and put your foot on the
brake pedal.
With the vehicle stationary, you must switch off
the ignition and then start the engine again.
The Stop & Start system requires a
12
V battery with a special specification
and technology.
The warning lamp in this button
flashes and a message appears,
accompanied by an audible signal.
In the event of a fault with the
system, this warning lamp flashes in
the instrument panel.
All work on this type of battery must
be done by a CITROËN or a qualified
workshop.
For more information on the
12 V battery, refer to the corresponding
section.
To Next Page
Loading...
