286
Practical information
Jumpy_en_Chap07_info-pratiques_ed01-2016
F After emptying the bottle, wipe away any
spillage around the tank filler using a damp
cloth.
If any additive is split or splashed, wash
immediately with cold water or wipe with
a damp cloth.
If the additive has crystallised, clean it
off using a sponge and hot water.
F
Refit the blue cap to the tank and turn it
a
6
th
of a turn clockwise, to its stop.
Important: when topping-up after
running out of additive, signalled
by the message "Top up emissions
additive: Starting prevented", you
must wait for about 5 minutes before
switching the ignition on again, without
opening the driver's door, unlocking
the vehicle, introducing the remote
control key into the ignition switch,
or placing the electronic key of the
"Keyless Entry and Starting" system
inside the vehicle.
Switch on the ignition, then wait for
10 seconds before starting the engine.
F Obtain a bottle of AdBlue
®
. After first
checking the use-by date, read carefully
the instructions on use on the label before
pouring the contents of the bottle into your
vehicle's AdBlue
®
tank.
Freezing of the AdBlue
®
AdBlue
®
freezes at temperatures below
around -11°C.
The SCR system includes a heater
for the AdBlue
®
tank, allowing you to
continue driving in very cold conditions.
F
Refit the black cover, starting at the top.
F
Close the door.
To Next Page
Loading...
