CITROEN Jumpy 2020 - Page 308

306
In the event of a breakdown
Jumpy_en_Chap08_En-cas-de-panne_ed01-2016
When refitting the connector and bulb
in the lamp, push the assembly into its
housing until it clicks into place.
Dipped beam headlamps
(halogen headamps)
Type C, H7-55W
Daytime running lamps
(halogen headlamps)
Type A, W21W LL-21W
Sidelamps
(halogen headlamps)
Type A, W5W
F
Press the upper clip on the cover then tip it
rearwards to remove it.
F Press the lower clip on the electrical
connector and remove the assembly of
connector and bulb.
F
Pull the bulb out and change it.
To refit, carry out these operations in reverse
order.
F
Press the upper clip on the cover then tip it
rearwards to remove it.
F Press the two side clips on the electrical
connector and remove the assembly of
connector and bulb.
F
Pull out the bulb and change it.
To refit, carry out these operations in reverse
order.
F
Press the upper clip on the cover then tip it
rearwards to remove it.
F Press the two side clips on the electrical
connector and remove the assembly of
connector and bulb.
F
Pull the bulb out and change it.
To refit, carry out these operations in reverse
order.