314
In the event of a breakdown
Jumpy_en_Chap08_En-cas-de-panne_ed01-2016
To refit, press on the lens to clip it in place.
F Unclip the trim at each end by turning it
upwards.
F Pull on the trim to disengage the central
clips, then remove it.
F Using a screwdriver through the aperture,
push the lamp towards the outside.
F Disconnect the electrical connector.
F
Remove the lamp.
F
Turn the bulb holder a quarter turn anti-
clockwise.
F Change the failed bulb.
To refit, carry out these operations in reverse
order.
To refit the lamp and trim, press on them to clip
them in place.
Third brake lamp
(tailgate)
Type A, W5W-5W
Number plate lamps
(tailgate)
Type A, W5W-5W
F Open the tailgate. F Insert a thin screwdriver into one of the cut-
outs in the lens.
F Push it outwards to unclip it.
F
Remove the lens.
F
Change the failed bulb.
To Next Page
Loading...
