68
Access
Jumpy_en_Chap02_ouvertures_ed01-2016
Back-up control(s)
If the alarm is activated, the audible
signal triggered on opening a door
with the key (integral with the remote
control) will stop when the ignition is
switched on.
Integral key
Locking the driver's door
Unlocking
F Insert the integral key into the door lock,
then turn it to the front.
If your vehicle has an alarm, it will not
be deactivated/activated on unlocking/
locking the vehicle.
Opening a door will trigger the alarm,
which can be stopped by switching the
ignition on.
To deadlock the vehicle, turn the key
again within five seconds of locking.
Locking the front passenger door
F Open the door.
Unlocking
F Use the interior door handle.
It is used to lock and unlock the vehicle when
the remote control cannot operate:
-
cell battery flat, vehicle battery discharged
or disconnected, ...
- vehicle located in an area with strong
electromagnetic signals.
F
Press and hold button 1 to extract the
integral key 2.
F
Insert the integral key into the door lock,
then turn it to the rear.
F Remove the cap on on the edge of the
door.
F
Insert the key into the latch aperture
(without forcing) and turn the assembly.
F Remove the key and refit the cap.
F
Close the door and check from the outside
that the vehicle has locked correctly.
To Next Page
Loading...
