[SMB-66E]
－ 78 －
COMMUNICATION
FUNCTIONS
6.2 Communication Error
When an error is caused due to communications during Teaching Pendant operation, the following
error message is displayed.
The displayed error message includes an error code. Refer to the following table and check.
Error code
Description of error
1
Reception data does not reach for 10 seconds from ABSODEX driver after data
is sent.
2
The reception action is not stopped for 60 seconds or over even after the
storage buffer capacity is surpassed.
3
Reception data does not reach for 10 seconds while the program is loaded in
the copy mode.
4 "" is sent back during reception while the program is loaded in the copy mode.
5 "" is sent back during reception while the program is stored in the copy mode.
※
※※
※ After checking, turn the control power off.
ＣＯＭ ＥＲＲＯＲ ×
ＰＷＲ ＯＦＦ
To Next Page
Loading...