Hydraulic / Electric System LINER TIC
4-14 10/04
1.3.1 Manual control
Manual control is used for diagnosis purposes.
Individual functions (valves) are checked.
Switching on manual
control:
Press key 3 (working position) and key 6 (front swath width)
simultaneously for approx. 7 seconds.
The flashing mode of LED 10 changes.
Key functions when
manual control is active
Folding up the rear rotors Press key 4 (transport position).
Lowering the rear rotors Press key 3 (working position).
Folding up the front rotors Press key 7 (fold up front rotors).
Lowering the front rotors Press key 8 (lower front rotors).
Increasing the front swath
width
Press key 5 (increase working width)
Decreasing the front swath
width
Press key 6 (decrease working width)
Raising/lowering the
chassis
Press key 9 (turning area) and hold it (chassis is raised or lowered).
Notes:
• All functions only work as long as the corresponding key is pressed.
• When the control unit is in this mode, all safety circuits are shut
down. When the swather is in working position, do not lower the
chassis!
• After shutting down the control unit, it will resume normal operation
when switching it on the next time.
To Next Page
Loading...
Need help?
General
