Claas LINER 3000 - Setting the Rotor Raise Height

Hydraulic / Electric System LINER TIC
4-18 10/04
1.3.3 Setting the rotor
raise height
Activating the setting mode: Press key 3 and key 7 simultaneously for approx. 3 seconds.
The flashing mode of LED 10 changes.
Go to the desired rotor
positions using keys 5 – 8:
Key 5: Raising the rear rotors.
Key 6: Lowering the rear rotors.
Key 7: Raising the front rotors
Key 8: Lowering the front rotors
Saving the settings When the desired setting has been reached, save this setting by pressing
key 9.