Clarius Scanner HD3 Clarius Power Fan HD3
revision 9 32
• Ingress Protection: IP00
• Mode of Operation: Continuous
Setting Up the Clarius Charger HD3
To use the Clarius Charger HD3:
1. Clean and disinfect the scanners before placing them in the Clarius Charger HD3.
For cleaning instructions, see Cleaning the Clarius Scanner HD3 on page 36. For
disinfecting instructions, see Disinfecting the Clarius Scanner HD3 on page 38.
2. Connect the Micro USB cable to the Clarius Charger HD3.
3. Connect the USB A to the power supply.
4. Insert the AC male plug into a power source.
The Clarius Charger HD3 is now ready to use.
Clarius Power Fan HD3
Attach the Clarius Power Fan HD3 to the built-in heatsink of the Clarius Scanner HD3 to extend
scanning time.
To attach the Clarius Power Fan HD3:
1. Align the top of the fan with the top of the scanner.
Make sure the fan’s logo is facing towards you. The logo on the fan and the logo on
the scanner should align on top of each other.
2. Press the top of the fan onto the top of the scanner until the fan snaps into place.
When the scanner reaches a temperature of 35°C (95°F), the fan automatically
activates.
To remove the Clari us Power Fan HD3:
1. Pull on the latch located on either side of the fan.
This loosens the fan from the scanner.
2. Lift the fan off the scanner.
To Next Page
Loading...