2 – 3
13.1.1 BATTERY LEVEL DISPLAY
It displays the status of charging. When the key is ON, the status of battery
level is displayed according to the charging condition. When charging is
completed, all lamps light up, and according to the degree of discharging, lamps
are distinguished downwards from the top. When the last lamp remained On,
the lamp begins to flicker. When the last lamp is distinguished, all the lamps
on the battery level display flicker, and charging message is displayed on the
letter information display. At that time, start to charging the battery. This machine
is intended to limit traveling work and hydraulic work automatically to prevent
overdischarge nd to lengthen the battery life, if the battery goes below a certain
electric pressure. Therefore charge at the right time, otherwise the machine will
stop.
13.1.2 TRAVEL POWER DISPLAY
It displays the status of power of the traveling system. When the key is ON,
the display is ON and set to 100%. It is intended to save energy by reducing
10% of power whenever each lamp is distinguished. At that time, mobility and
gradeability are reduced but service hour of this machine is increased. If the
machine is operated on the unlevelled ground or it is overloaded, operate it
with 100% of power mode. If the machine is operated on the level ground or
it is lightly loaded, reduce the power appropriately in order to work more
effectively. The travel power can be controlled with “Power Up” and “Power
Down” of Function selection switch.
13.1.3 HYDRAULIC POWER DISPLAY
It displays the status of power of the hydraulic system. When the key is ON ,
Power is set. If power mode is selected and lift level is pulled down fully. If
power mode is released , the certain amount of power is reduced in
operating. If you select and adjust hydraulic power according to loading status,
you can use the machine more effectively. Control switch of hydraulic power is
controlled with “Hydraulic power” of Function selection switch freely.
13. DRIVING AND OPERATING