2 – 4
13.1.4 REGENERATIVE BRAKING DISPLAY
The system that increase service hour of the machine by recharging the battery
with electric energy, which is produced when electric braking is applied. When
the battery is recharged with the energy successfully, main display lamp
lights up. When the charging is completed, the lamp is distinguished
automatically, therefore the status of recharging is notified immediately.
13.1.5 LETTER INFORMATION DISPLAY
It displays the current status of the machine. When the key is ON, the status
of all parts of the machine, such as traveling system, hydraulic system, and
steering system are inspected by the controller and displayed on this display.
If the machine is in normal condition, “READY OK” and model name are
displayed. Before operating the machine, make sure that “READY OK” is
displayed.
13.1.6 TOTAL SERVICE HOUR/ TRAVEL DISTANCE/TRAVEL SPEED DISPLAY
It displays total service hour, travel speed, total travel distance, and fixed travel
distance. When the key is ON, firstly total service hours are displayed, After
traveling, current travel speed is displayed instead of total service hours. When
the key is back to neutral position, total service hours are displayed
automatically. Travel distance is displayed by operating function selection switch.
For display of travel distance, there are total travel distance display and temporal
distance display that specified distance is calculated since the operator set.
Temporal travel distance is reset anytime according to operator’s selection, so
it makes operator check the working distance for certain period.
13. DRIVING AND OPERATING
To Next Page
Loading...
