2 – 12
2) ENTER SWITCH
This switch is to select a mode that operator desires.
Refer to “1) Mode switch” for usage.
3) TRAVEL SPEED SET SWITCH
The switch is to travel constantly at a preset speed, which consists of 5
levels; 3, 4, 5, 6, 7km/hr. If pressing this switch. a turtle mark is displayed
on LCD and the corresponding speed is shown on the letter display panel.
Each time the switch is pressed, the display shifts in order of 3km/hr –
4km/hr – 5km/hr – 6km/hr – 7km/hr, and EXIT[ENTER]. Accordingly when
operator turns the travel lever “ON” after stopping at the setup speed, the
machine travels only at the constant speed. If operator wants to release the
function while setting the Traveling speed, keep pressing the switch until
“EXIT[ENTER]” comes out and then press “ENTER” switch. The turtle mark
on LCD will disappear and the machine will return to the normal traveling
mode.
4) HYDRAULIC POWER SWITCH
The switch is to set/release the hydraulic power mode. It is set to power
ON mode when the key switch is “ON”. Each time the switch is pressed,
the power mode ON/OFF is selected alternatively. In power ON mode,
hydraulic bypass connector works and the output of hydraulic system reaches
the maximum of setup value, so that the power mode is suitable for overload
working. In power release mode, the hydraulic bypass connector doesn’t work
and the output of hydraulic system goes down, so that this mode is to save
energy from over-consumption and also increase the running time when the
machine is operated in light loaded works.
5), 6) TRAVEL POWER UP/DOWN SWITCH
The switch is to adjust the power of Traveling system. It is adjustable by 4
levels and the maximum output, the 4th level is set when the key switch is
“ON”. If pressing the power down switch, the power is decreased as 10%
step. Proper power adjustment under certain working conditions enables the
machine running time increased.
13. DRIVING AND OPERATING
To Next Page
Loading...
