3 – 11
If following failures occur while using the machine, check according to the checking
point. (If there are any problems, make contact to your local dealer.)
When checking, surely turn off the start switch and disconnect the battery plug.
24. GUIDE TO REPLACE AND REPAIR PARTS
Failure
LCD is not turned on
and the machine is
not operated
The machine is not
operated
Attachments
(hydraulic) are not
operated
Steering isn’t
performed
Lamps, horn, or
back alarms aren’t
operated
Charging isn’t
performed
Other abnormal parts
in the machine
Checking items
1. Make sure that the battery plug is connected properly.
2. Make sure that the fuse of key switch in fuse box is
normal.
3. Make sure that connector of LCD is connected.
1. Check if there is abnormality on LCD.
2. If there is no abnormal part on LCD, depress the brake
pedal, and make sure that micro switch is operated
normally.
1. Check if there is abnormality on LCD.
2. If there is no abnormal part on LCD, pull the hydraulic
lever, and make sure that micro switch is operated
normally
1. Check if there is abnormality on LCD.
2. Make sure that the EPS fuse in fuse box is normal.
1. Make sure that the convert fuses (CER15/25) in fuse
box are normal.
2. Make sure that relevant fuse in fuse box is normal
1. Check if the plug of charging code is disconnected or
loose.
2. Make sure that the charger fuses for AC or DC are
normal.
3. Check the input power of the charger
1. Check if there are abnormal parts on LCD.
(Contact to your local dealer.)
To Next Page
Loading...
