Section 6. Planned Maintenance
6.3
Safe Maintenance Practices
The following instructions have been prepared from current industry and
government safety standards applicable to industrial truck operation
and maintenance. These recommended procedures specify conditions,
methods, and accepted practices that aid in the safe maintenance of
industrial trucks. They are listed here for the reference and safety of all
workers during maintenance operations. Carefully read and understand
these instructions and the specifi c maintenance procedures before
attempting to do any repair work. When in doubt of any maintenance
procedure, please contact your local CLARK dealer.
1. Electric powered industrial trucks can become hazardous if main-
tenance is neglected. Therefore, suitable maintenance facilities
and trained personnel and procedures shall be provided.
2. Maintenance and inspection of all industrial trucks shall be per-
formed in conformance with the manufacturer's recommenda-
tions.
3. Follow a scheduled planned maintenance, lubrication, and inspec-
tion system.
4. Only trained and authorized personnel are permitted to maintain,
repair, adjust, and inspect industrial trucks—and must do so in
accordance with the manufacturer's specifi cations.
5. Always wear safety glasses. Wear a safety (hard) hat in industrial
plants and in special work areas where protection is necessary
and required.
6. Properly ventilate work area, keep shop clean and fl oors dry.
7. Avoid fi re hazards and have fi re protection equipment present in
the work area. Do not use an open fl ame to check for leakage.
Do not use open pans of fuel or fl ammable cleaning fl uids for
cleaning parts.
8. Before starting work on truck:
a. Raise drive wheels free of fl oor and use oak blocks or other
positive truck positioning devices.
b. Remove all jewelry (watches, rings, bracelets, etc.).
c. Put oak blocks under the load-engaging means, upright rails,
or chassis before working on them.
d. Disconnect the battery receptacle before working on the elec-
trical system.
Safe Maintenance Practices
To Next Page
Loading...
