Section 6. Planned Maintenance
6.5
Planned Maintenance Intervals
WARNING
Always put oak blocks under the carriage and upright
rails when it is necessary to work with the upright in an
elevated position.
16. The truck manufacturer's capacity, operation, and maintenance
instruction plates, tags, or decals must be maintained in legible
condition.
17. Batteries, limit switches, protective devices, electrical conduc-
tors, and connections must be maintained in conformance with
good practice. Special attention must be paid to the condition of
electrical insulation.
18. To avoid injury to personnel or damage to the equipment, consult
the manufacturer's procedures in replacing contacts on any bat-
tery connection.
19. Industrial trucks must be kept in a clean condition to minimize fi re
hazards and help in detection of loose or defective parts.
20. Modifi cations and additions that affect capacity and safe truck
operation must not be done without the manufacturer's prior writ-
ten approval. Capacity, operation, and maintenance instruction
plates, tags, or decals must be changed accordingly.
To Next Page
Loading...
