EasyManuals Logo

Clarke Focus II User Manual

Clarke Focus II
139 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #5 background imageLoading...
Page #5 background image
ENGLISH
4
Operators Manual - FOCUS
®
II L17 - S20 - L20 - L20 Cyl. - BOOST
®
L20
WARNING! The machine storage temperature must be between +32°F and +104°F (0°C and +40°C).
WARNING! The humidity must be between 30% and 95%.
WARNING! Do not use the machine as a means of transport.
WARNING! Do not use the machine on slopes with an inclination higher than 2%.
WARNING! Do not allow the brushes to operate while the machine is stationary to avoid damaging the oor.
WARNING! In case of re, use a powder re extinguisher, not a water one.
WARNING! Do not tamper with the machine safety guards and follow the routine maintenance instructions
scrupulously.
WARNING! Do not allow any object to enter into the openings. Do not use the machine if the openings are clogged.
Always keep the openings free from dust, hairs and any other foreign material which could reduce the air
ow.
WARNING! Do not remove or modify the plates afxed to the machine.
WARNING! If the machine is used according to the instructions, the vibrations are not dangerous. The machine
vibration level is less than 98.42 in/s
2
(2.5 m/s
2
) (98/37/EEC - EN 1033/1995).
WARNING! This machine cannot be used on roads or public streets.
WARNING! Pay attention during machine transportation when temperature is below freezing point. The water in the
recovery tank or in the hoses could freeze and seriously damage the machine.
WARNING! Use the brushes and pads supplied with the machine and those specied in the Operator's Manual.
Using other brushes or pads could reduce safety.
WARNING! In case of machine malfunctions, ensure that these are not due to lack of maintenance. If necessary,
request assistance from the authorized personnel or from an authorized Service Center.
WARNING! If parts must be replaced, require ORIGINAL spare parts from an authorized Dealer or Retailer.
WARNING! To ensure machine proper and safe operation, the scheduled maintenance shown in the relevant chapter
of this Manual, must be performed by the authorized personnel or by an authorized Service Center.
WARNING! Carefully read all the instructions before performing any maintenance/repair procedure.
WARNING! Do not wash the machine with direct or pressurized water jets, or with corrosive substances.
WARNING! The machine must be disposed of properly, because of the presence of toxic-harmful materials
(batteries, etc.), which are subject to standards that require disposal in special centers (see Scrapping
chapter).
B ENGLISH.indd 4 14/04/2010 12.47.48

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Clarke Focus II and is the answer not in the manual?

Clarke Focus II Specifications

General IconGeneral
Cleaning Path20 inches
Power SourceBattery
Brush Motor0.75 hp
Battery Voltage24 V
Voltage36V
Vacuum Motor0.5 hp

Related product manuals