Clarke Vantage 17 E - Maintenance and Servicing; Scheduled Maintenance Table

INSTRUCTIONS FOR USE ENGLISH
9099653000 - VANTAGE 17 E 17
MAINTENANCE
The lifespan of the machine and its maximum operating safety are ensured by correct and regular maintenance.
The following chart provides the scheduled maintenance. The intervals shown may vary according to particular working conditions,
which are to be dened by the person in charge of the maintenance.
WARNING!
Maintenance procedures must be performed with the machine switched off and the power supply cable plug
disconnected from the electrical mains.
Moreover, carefully read the instructions in the Safety chapter.
All scheduled or extraordinary maintenance procedures must be performed by qualied personnel, or by an authorised Service
Center.
This Manual describes only the easier and most common maintenance procedures.
NOTE
For other maintenance procedures shown in the Scheduled Maintenance Table, refer to the Service Manual that can be
consulted at any Service Center.
SCHEDULED MAINTENANCE TABLE
Procedure
Daily, after
using the
machine
Weekly
Every six
months
Yearly
Squeegee cleaning
Brush cleaning
Tank and vacuum grid cleaning
Power supply cable check
Squeegee blade check and replacement
Solution lter cleaning
Screw and nut tightening check (1)
Vacuum system motor carbon brush check and replacement (2)
(1) And after the rst 8 working hours.
(2) This maintenance procedure must be performed by an authorised Clarke Service Center.
9099653000 - 07-2012.indb 17 24-Jul-12 15:17:47