Need help?Do you have a question about the Clawgear Mission Sensor and is the answer not in the manual?
The Watch provides 4 different symbols to indicate the forecast weather.
The Watch includes two daily alarms: Daily Alarm 1 and Daily Alarm 2.
To turn ON/OFF the Daily Alarm 1 (2), press the [L/R] button in Daily Alarm 1 (2) Display.
To select the setting display, hold the [M] button for about 2 seconds.
The chronograph can measure elapsed time without stopping the counting - lap time.
To recall lap time, hold down the [M] button in the Chronograph Display.
To record a new set of lap time, hold the [L/R] button for 2 seconds when it is stopped.
When the chronograph is stopped (not counting), press the [S/S] button once to start the chronograph.
To record a new set of elapsed time, hold the [L/R] button for 2 seconds.
The Watch includes a countdown timer feature: the Timer Mode.
To select the setting display, hold the [M] button for 2 seconds, and the digits have been selected will flashing.
To select the setting display, hold the [M] button for 2 seconds and the digits have been selected will flashing.
When the Timer is set, press the [S/S] button to start the timer. Press the [S/S] button once again to stop the timer.
In the last 10 minutes, the Watch will beep for every minute.
The last target time will be reloaded automatically at the end of the 30-second beep sound.
The watch can stores up to 34 past hourly data including altitude and temperature.
To select the setting display, hold the [M] button for 2 seconds, the word 'SET' and the flashing value of altitude will appear.
In order to adjust the altitude to default value, select 'YES' in Set Default Display.
The watch can stores up to 34 past hourly data including sea level pressure and temperature.
The Watch can measure relative altitude. For example, it can measure the ascending or decending altitude.
The watch will updated the reading automatically. For the first 5 minutes, it will updated every second.
To select the setting display, hold the [M] button for 2 seconds, the word 'SET' and the flashing value of pressure will appear.
In order adjust the pressure to default value, select 'YES' in Set Default Display.
Keep your Watch away from magnets or any appliances which may contain magnetic objects.
If no key is pressed for about 1 minute, the watch will go to the IDLE Mode automatically.
If distortion is detected, the bearing direction will flash.
The direction of an object from a point can be specified in either compass directions or bearing directions.
The Bearing direction of an object is defined as the angular difference between North and the object.
Spot two distant identifiable landmarks like mountains, light-house, fort or building from yourcurrent position.
During a trekking, the Watch can keep your course in a correct way.
Most topographic maps include a small arrow which shows the magnetic north pole and magnetic declination information.
The Watch has to employ a compass calibration in one of the following conditions.
The compass calibration includes two different processes: Rotation Calibration Mode and Magnetic Declination Setting.
When the battery-low indicator appears on the display, it means that the capacity of the battery is low.
To enter the Power Saving Mode, hold down the [L/R] button in Current Time Mode for about 5 seconds.
To Next Page
General