Clawgear Mission Sensor - 9.1 Altimeter Mode - Setting the Altimeter; How to Set the Altitude and Sea level pressure; Reset to Default

How to Set the Altitude and Sea level pressure
• To select the setting display, hold the [M] button for 2
seconds, the word “SET” and the flashing value of
altitude will appear.
• In the setting display, press the [M] button to change the
selection between altitude, sea level pressure and
default setting.
• When the digits are flashing (selected), press the [S/S]
or [L/R] button to increase / decrease the number. (Hold
down the button to change the number at a higher
speed).
Reset to Default
• In order to adjust the altitude to default value, select
“YES” in Set Default Display as adjacent diagram,
press [M] to confirm and “Done!” message will be
shown.
• To exit the Adjustment Display, hold the [M] button for 2
seconds, and the Watch will go back to the Altimeter
Mode.
9.1 Altimeter Mode - Setting the Altimeter
Altimeter Setting Sequence
hold [M] hold [M]
2 seconds
[M]
[M]
[M]
[M]
Altimeter Display
Sea level pressure display
Recall last setting
value display
“No” display
“YES” displayDone display
Done display
hold [S/S] / [L/R]
[S/S] /
[L/R]
[S/S] / [L/R]
Increase/Decrease
the number
Increase/Decrease
the number at a
higher speed
2 seconds