Clawgear Mission Sensor - 11.1 Barometer Mode - Setting the Pressure; How to Set the Barometer; Reset to Default

How to Set the Barometer
• To select the setting display, hold the [M] button for 2
seconds, the word “SET” and the flashing value of
pressure will appear.
• In the setting display, press the [M] button to adjust the
pressure.
• When the digits are flashing (selected), press the [S/S]
or [L/R] button to increase / decrease the number. (Hold
down the button to change the number at a higher
speed).
Reset to Default
• In order adjust the pressure to default value, select
“YES” in Set Default Display as adjacent diagram, press
[M] to comfirm and “Done!” message will shown.
• To exit the Adjustment Display, hold the [M] button for 2
seconds, and the Watch will go back to the Barometer
Mode.
11.1 Barometer Mode - Setting the Pressure
Barometer Setting Sequence
hold [M]
2 seconds
[M]
[M]
[M]
Barometer Display
Pressure display
“NO” display
“YES” display
Done display
Done display
hold [S/S] / [L/R]
[S/S] /
[L/R]
[S/S] / [L/R]
Increase/Decrease
the number
Increase/Decrease
the number at a
higher speed
hold [M]
2 seconds