ClearSounds CSC600 - Adjust audio; Handset tone and volume

2726
Adjust the display
Digit size
By default, if you dial more than eight digits, the
digit size decreases so that more digits show on
the screen.
If you prefer to always see the largest sized digits,
you can turn off the DIM:X setting.
To adjust digit size
1. Press beneath Menu on the screen.
2. Press
.
Set Display is selected.
3. Press
and scroll down to DIM:X---->x, and
then press
.
4. Press
and scroll to ON or OFF, and then
press
.
5. Press
until you arrive at the home
screen.
Adjust audio
WARNING: Excessive volume and amplication
can cause hearing loss.
Handset tone and volume
To adjust handset earpiece tone and volume
• Near the top of the phone base, adjust
.
To amplify tone and volume
By default, this adjustment remains until you end the call.
• Press
.
Next to
, glows red while AMP is on.
Tip: If you prefer amplication to be on every time
that a call begins, on the back of the phone base,
move the
switch to ON. During conversation,
you can still turn off amplication by pressing .