2. Hold the ClearSounds wall mount bracket ( )
with the raised mounting pins facing you. Orient
the bracket so that the opening is at the bottom.
3. Run
through the opening on ,
and push excess cord behind the plate.
4. Attach
to the phone:
a.Line up the keyholes on back of the phone
with the raised mounting pins on
.
b.Pull
toward the phone.
c.Slide upward until it is securely seated.
5. Connect
to on the wall.
6. Slide
over the phone jack wall plate.
To simply hang the phone on the wall
This method requires two self-tapping screws (not
included).
1. Locate a wall location within 6 feet of a telephone
jack wall plate and within 9 feet of an AC power
outlet.
2. Install the screws on the wall in a vertical line, at
a distance of 3.15 inches from each other.
3. Line up the keyholes on back of the phone over
the screws, and slide the phone downward until
it is securely seated.
4. Connect to on the back of the
phone base, and then connect it to
in the wall.
To connect to AC power
1. Connect to on the back of the
phone base, and then connect it to an AC power
outlet in the wall.
Note: is required for the phone to function
properly.
2. Connect
to on the , and then
connect it to on the left side of the .
A dial tone indicates that the phone is properly
connected.
If you subscribe to DSL phone service
If you hear noise during conversations or if the
Caller ID function does not work properly, please
obtain and attach a DSL noise lter.
Attach the lter between the telephone cable and
the telephone communication jack in the wall.
To Next Page
Loading...
