The ClearSounds CSC600 is compatible with these
assistive listening devices:
• Hearing aids that are equipped with telecoil
(T-coil)
• Audio neckloops, with or without built-in
microphones.
Neckloops amplify phone sound in T-coil-
equipped hearing aids.
To use the phone with T-coil-equipped hearing
aids
1. Move your hearing aid T-switch to the T position.
2. Hold the handset close to your hearing aid.
To use the phone with an audio-only neckloop
You must use an audio-only neckloop with the
handset or the speakerphone.
1. Connect an audio neckloop to the 3.5 mm AUDIO
NECKLOOP jack on the rear of the phone base.
2. Position the neckloop around your neck.
3. Place or answer calls as usual.
4. Adjust handset or speakerphone volume as
usual.
To use the phone with a neckloop that includes
a built-in microphone
1. Before or during a call, connect the neckloop
to the 2.5 mm
jack on the left side of the
phone base.
2. Position the neckloop around your neck.
3. Press
. to accomplish these tasks:
• If you connected the neckloop during a call,
hear and speak through the neckloop.
• Place a call.
• Answer a call.
• End a call.
4. To adjust volume, use
and
.
To Next Page
Loading...
