TO: Owners, Operators and Maintenance Personnel
This operating manual presents information that will help to properly operate and care for the equipment. Study its contents carefully.
The unit will provide good service and continued operation if proper operating and maintenance instructions are followed. No attempt
should be made to operate the unit until the principles of operation and all of the components are thoroughly understood. Failure to
follow all applicable instructions and warnings may result in severe personal injury or death.
It is the responsibility of the owner to ensure all service, repair, and operating personnel have received proper safety training.
Proper operating techniques and maintenance procedures must be followed at all times. Although the components supplied afford a
high degree of protection and safety, due attention is required to the dangers and hazards inherent in handling and firing of fuel.
“Automatic” features, where present, should not be understood as substituting for the normal responsibilities of the attendant. Such
features merely alleviate certain repetitive chores, allowing more time for proper upkeep of the equipment.
This manual is intended for a general scope of application. Because of state, local, or other applicable codes, controls and safety de-
vices may vary considerably from those described herein.
It is recommended that a boiler room log or record be maintained. Recording of daily, weekly, monthly and yearly maintenance activ-
ities and recording of any unusual operation will serve as a valuable guide to any necessary investigation.
Most instances of major boiler damage are the result of operation with low water. We cannot emphasize too strongly the need for the
operator to periodically check the low water controls and to follow good maintenance and testing practices. Cross-connecting piping
to low water devices must be internally inspected periodically to guard against stoppages which could obstruct the free flow of water
to the low water devices. Float bowls of these controls, where applicable, must be inspected frequently to check for the presence of
foreign substances that would impede float ball movement.
The waterside condition of the pressure vessel is of extreme importance. Waterside surfaces should be inspected frequently to check
for mud, sludge, scale and corrosion.
It is essential to obtain the services of a qualified water treating company or a water consultant to recommend the proper boiler water
treating practices for your specific application.
The operation of this equipment must comply with all requirements or regulations of the owner’s insurance company and/or other
authority having jurisdiction. In the event of any conflict or inconsistency between such requirements and the warnings or instructions
contained herein, please contact Cleaver-Brooks before proceeding.
DO NOT OPERATE, SERVICE, OR REPAIR THIS EQUIPMENT UNLESS YOU FULLY UNDERSTAND ALL
APPLICABLE SECTIONS OF THIS MANUAL.
DO NOT ALLOW OTHERS TO OPERATE, SERVICE, OR REPAIR THIS EQUIPMENT UNLESS THEY FULLY
UNDERSTAND ALL APPLICABLE SECTIONS OF THIS MANUAL.
FAILURE TO FOLLOW ALL APPLICABLE WARNINGS AND INSTRUCTIONS MAY RESULT IN SEVERE
PERSONAL INJURY OR DEATH.
!
DANGER
WARNING
To Next Page
Loading...
Need help?
General
