Modules & Options
7 - 50 3G Module
7
3G Module
If you have included an optional (factory option only) UMTS/HSPA+ based 3G
Module (Universal Mobile Telecommunications System
or High Speed Packet Ac-
cess) module (see “Communication” on page D - 3 for specification details) in your
purchase option, you do not require a driver/application installation for Windows
8. Follow the instructions overleaf to install the USIM card (which will be provided
by your service provider), and then use the Charms Bar Wireless icon to access
the 3G network in the same manner as the WLAN (see page 7 - 52).
Important Notice
If your purchase option includes both Wireless LAN and 3G modules, then the appropriate
antennas will be installed. Note that In order to comply with FCC RF exposure compliance
requirements, the antenna must not be co-located or operate in conjunction with any other
antenna or transmitter.
Important Notice - 3G & Bluetooth/Wireless LAN Modules
In order to comply with FCC regulations you should NOT operate the 3G module and the
Bluetooth/Wireless LAN modules at the same time as this may disrupt radio frequency, and
cause interference. When the 3G module is powered on, make sure that the Bluetooth/
Wireless LAN modules are powered off.