Climate Wizard CW-H10 - Installation Checklist

31
SeeleyInternationalPtyLtd
INSTALLATIONCHECKLIST
The cooler is adequately supported, secure and level.
thecoolerwasmade.
he water is connected with no leaks at fittings.
Waterpipesarecorrectlysaddledaspertheapplicableplumbing
regulations.
The drain water does not discharge onto the roof surface.
The power supply adheres to all local and national regulations and is wired
back to the distribution board on its own separate circuit.
cableshavebeencorrectlyconnectedtothecontrolboxes(i.e.power
supply,controlcable)
Theownerhasbeeninstructedhowtheycanelectricallyisolatethecooler
atthemeterboxincaseofanemergency.
All ducts are fixed correctly and there are no air leaks.
Thesystemhasbeenrunfromthecustomerswallcontrolandallfunctions
workcorrectly.
Theairbalanceforalloutletshasbeenadjustedtothecustomers
satisfaction.
Thecustomerhasbeenshownhowtooperatethesystem.
All the installation rubbish has been removed and, if applicable, any property
damage repaired.
Signed by Installer: …………………………………………………
Dated: ………………………………………………………………
Thewaterpipeswereflushedofanyforeignmaterialsbeforeconnection
to
T
The owner has been instructed on how to isolate the water to the system in
case of emergency.
All
OwnersName:
Telephone:
Address:
Dealer:
Installer:
DateInstalled:
ModelNo.:
SerialNo.:
859736-A AU1007