Cloos GLC 353 MC3 User Manual

B-21
Welding
GLC 353/503/553 MC3
- Select the required Welding current by turning
Potentiometer 1 on the wire drive operation panel.
The set welding current can be read on Display 2
on the power source.
- Begin welding.
Poti 1 Caution!
Protect eyes and skin against arc
radiation! Wear protective clothing !
- Carry out test welds and optimize the setting by
turning Potentiometer 1.
- The actual weld parameters voltage and current are
shown on Display 1 - position Volt -
and on Display 2 - position Ampere.
Note: If you select A
Hold
on Display 2 the maximum welding current used during
welding can be read at the end of the welding process.
B2.5 Coated Stick Electrodes

Cloos GLC 353 MC3 Specifications

General

Brand	Cloos
Model	GLC 353 MC3
Category	Welding System
Language	English