Cloos GLC 353 MC3 User Manual

B-25
Programming
GLC 353/503/553 MC3
Operating mode Super 4 cycle:
Program steps
Welding arc active
Squeeze trigger Release trigger Squeeze trigger Release
trigger
Welding torch trigger engagement(s)
The program steps Start program with start ramp and End crater program with end crater
ramp distinguish the operating modes 2 cycle/4cycle and the operating mode
Super 4 cycle.
Operating mode Prog
Program steps
Welding arc active
Welding torch trigger
In operating mode Prog the program steps Main parameter 2 and Main parameter 3 are
possible. When touching the welding torch trigger you can select between 3 settings. When
pressing the welding torch trigger for < 0,3 seconds only, you remain within the program
steps 1,2,3.
This means if you are in program step 3 and press and release the torch trigger within 0.3
secs, the power sources changes to program step 1. The program step End crater ramp is
started only when pressing the trigger for a longer period.
P3 Betreibsarten beim Programmieren

Cloos GLC 353 MC3 Specifications

General

Brand	Cloos
Model	GLC 353 MC3
Category	Welding System
Language	English