Cloos GLC 353 MC3 User Manual

B-42
Options
GLC 353/503/553 MC3
O3 Remote controller
Remote controller connection
The remote controller enables you to change
values when welding takes place far away from
the wire drive unit. The remote controller is
connected at the wire drive operation panel. The
potentiometers 1 and 2 on the wire drive
operation panel are switched off as soon as the
remote controller has been plugged in.
Remote controller operation panel:
Call up the welding processes 1 to 7.
Change over from mode manual to
mode programming.
Potentiometer 2.1: Welding voltage
Arc length
Potentiometer 1.1: Wire feed speed
output
O3 Remote controller

Cloos GLC 353 MC3 Specifications

General

Brand	Cloos
Model	GLC 353 MC3
Category	Welding System
Language	English