Cloos qineo PULSE MASTER-Plus - Adjust Secondary Parameters; Restore Original Secondary Parameters; Parameter of Operating Modes 2-Cycles and 4-Cycles

20
MA_QN_MP
Operation
2.2.1 Adjust secondary parameters
1. Press the menu button.
2. Using the left rotary knob, select the menu for the secondary
parameters for the characteristic curve and confirm it by pressing the
knob.
3. Select the desired parameter by turning the left rotary knob and con-
firm your selection by pressing the knob.
4. Turn the rotary knob to change the default value and confirm the
correction value by pressing the knob.
5. To exit the menu, select the exit symbol by turning the rotary knob and
confirm by pressing the knob.
The correction values will be added to the original values. The parameters
of the original characteristic curve will not be changed.
2.2.2 Restore original secondary parameters
1. Press the menu button.
2. Using the left rotary knob, select the menu for the secondary
parameters for the characteristic curve and confirm it by pressing the
knob.
3. Set the correction value to "-0-".
4. To exit the menu, select the exit symbol by turning the rotary knob and
confirm by pressing the knob.
2.2.3 Parameter of operating modes "2-cycles" and "4-cycles"
• Gas pre-flow Correction value (Off, +/- 99)
• Inching-in Correction value (+/- 99)
• Start program (time) Correction value (Off, +/- 99)
• Start program (power) Correction value (+/- 99)
• Upslope Correction value (Off, +/- 99)
• Main power Absolute value (m/min)
• Downslope Correction value (Off, +/- 99)
• End crater prog. (time) Correction value (Off, +/- 99)
• End crater prog. (power) Correction value (+/- 99)
• Wire burnback Correction value (+/- 99)
• Gas post-flow Correction value (Off, +/- 99)
NOTICE!