38
MA_QN_MP
Configuration operating panel
3.9.2 User management and PAK
Depending on the user level for login or as registered user, a coloured
symbol appears at the top of the screen.
Operating level when switching on:
• "Automatic"
• "Programmer" / Configurator"
logged on user:
• "Automatic"
• "Programmer"
• "Configurator"
The access rights for certain functions, adjustments and welding
parameters are released or blocked and saved in a user profile via the user
management.
The user management allows to transfer these user profiles to a PAK
(Personal Access Key) each. For this, the welding power source or the
operating must dispose of a PAK port.
The PAK is connected to the PAK port of the welding power source and
the user profile is loaded. The user is automatically logged in the welding
power source as soon as the information saved on the PAK match with the
information saved in the power source. The respective user profile is then
activated.
If a user logs in who is new for the welding power source, the access is
either denied or his user profile is transferred into the user management
and stored, depending on the setting. The respective user profile is then
activated.
Press the "Hold" and "Key" buttons simultaneously until the configuration
menu appears.
To Next Page
Loading...
