109
– Check whether there is any leakage.
– Check whether there are visible defects: broken parts, cracks, etc.
– Check the device for correct chain tensioning.
– Check the function of the chain brake.
Starting the motor
– Stand in a secure position.
– Set the device on the ground so that the saw chain cannot
touch anything.
– Activate the chain brake (snap in the hand guard towards the
front).
– Hold the handle firmly with one hand and press the device on
the ground.
Motor cold start
►P.5, item7
– Set ignition switch(3) to[1].
– Gently press fuel pump(15) often enough that no more bubbles are visible
(approx.10times).
– Pull the choke lever(14) all the way out.
– Pull the pull starter(6) out evenly as far as it will go until you hear a first ignition sound.
– Push the choke lever(14) back in.
– Pull the pull starter(6) out evenly until the motor starts.
– Release the chain brake(10).
– Slightly press down on the throttle(16).
DANGER!
Danger of fire!
Due to any spilled fuel, the device can catch fire.
Wipe any spilled fuel up before starting.
Start the device a few metres away from the place where you have filled it.
DANGER!
Risk of injury!
When starting, the device must be seated quietly and firmly. Never leave the motor on
if you still have the device in your hand!
DANGER!
Risk of injury!
If the chain brake is not active, the saw chain starts up directly after the motor is
started. Always check the chain brake before starting the motor (►Checking the chain
brake– p.121)!
NOTICE!
Device damage!
Pull the pull-starter max. 50 cm out and let it run back in slowly by hand.
GB
Kettensaege_Benzin_462226.book Seite 109 Mittwoch, 10. Oktober 2012 2:43 14
To Next Page
Loading...
Need help?
General
