CNC-Step S-400 T - Tool Holder; Controls

Operating Instructions
High-Z T-Series
CNC-STEP GmbH & Co. KG ▪ Siemensstrasse 13-15 ▪ 47608 Geldern ▪ Germany
Page 37
Support: +49 (0)2831/91021-50
15.02.2014
Fig. 10c: X-Carriage
1 stop (M8 screw)
2 magnet holder of the X axis
3 mounting screw magnet holder (M6 screw)
The M8 screw (Fig. 10c / 1) serves as a stop for the magnet
holder (Fig. 10c / 2). This stop is required to locate the factory
setting, if for reasons of user-defined settings the magnet holder
was transferred.
To move the magnet holder (Fig. 10c / 2) loosen the fixing screw
(Fig. 10c / 3), move the magnet holder along the groove to the
desired position and secure with the fixing screw to prevent
loosening
HINT:
If the position of the magnet holder of the X-axis is changed, settings must be taken
into account in the control software under the topic “working space”.
4.3.5 Too l hold er
Fig. 11: Tool holder 43H7
On the tool holder of the Z-axis (Fig. 11/1) are some of the most
important additional available tools attached (see Appendix
"Accessories").
4.4 Controls
The machine does not have its own controls for moving the axes. This is possible with separate
interfaces (e.g. stepper motor control Zero3)
1
1
2
3