CNC-Step S-400 T - Maintenance; Cleaning of the Machine

Operating Instructions
High-Z T-Series
CNC-STEP GmbH & Co. KG ▪ Siemensstrasse 13-15 ▪ 47608 Geldern ▪ Germany
Page 63
Support: +49 (0)2831/91021-50
15.02.2014
8.4 Maintenance
8.4.1 Clea n i ng of t he ma chi n e
Regular maintenance of the machine prevents sticking of moving parts.
Property damage caused by compressed air!
Pressurized air can damage the ball screws of the T series machine.
• Never use compressed air to clean the T series machine!
Personnel:
• Operator
Safety equipment:
• protective clothing
• Safety shoes
• protective gloves
1
Turn power switch on the stepper motor control to "0" or "Off"; see separate operating
instructions for the step motor control.
2
Free machine from chips.
ATTENTION:
Risk of injury by chips!
Chips can be sharp and cause deep lacerations.
• Always wear protective gloves when removing chips.
3
Free ball screws, Trapezoidal Thread Spindle and linear guides from chips
4
Clean the entire machine with a slightly oily cloth DIN 61650