CNC-Step S-400 T - Activities During Operation; Operating Machine

Operating Instructions
High-Z T-Series
CNC-STEP GmbH & Co. KG ▪ Siemensstrasse 13-15 ▪ 47608 Geldern ▪ Germany
Page 55
Support: +49 (0)2831/91021-50
15.02.2014
3
Ensure that required tool is in the tool holder, if necessary, change the tool, and see the separate
operating instructions for the accessories.
4
Ensure that no tools or other foreign objects are in the machine or system.
5
Make sure that no persons are in the danger zone.
6
Connect required accessories to the provided power supply.
7
Switch on the stepper motor control; refer to the separate operating instructions for the step
motor control.
8
Perform reference run.
9
10
Zero point determination.
Start Job.
7.4 Activities during operation
7.4.1 Opera t i ng ma c h i ne
Personnel:
• Operator
Safety equipment:
• protective clothing
• Safety shoes
• Goggles
• protective gloves
• Hearing protection
• Protective cover
Rotary tools
WARNING:
Risk of injury from rotating tools!
In spindles clamped tools may result in serious personal injury or property damage.
• Before starting work, ensure that all covers and safety devices are installed
and working properly.
• • Do not reach into moving tool during operation.
• • Before replacing the tools always pull power plug of the milling motor or
turn off the machine and secure against reconnection.