CNC-Step S-400 T - Control Signals (ST); Motor Connector (X1,X2,Y,Z)

Operating Instructions
High-Z T-Series
CNC-STEP GmbH & Co. KG ▪ Siemensstrasse 13-15 ▪ 47608 Geldern ▪ Germany
Page 39
Support: +49 (0)2831/91021-50
15.02.2014
4.5.1 Cont rol si g nals ( ST )
Fig. 14: Belegung Steuerstecker
Sub-D
Pin Nr.
Signal
1
Limit C / Pin15 jack High-Z
2
limit X
3
limit Y
4
limit switch Z
5
Emergency stop (closed = OK, open = stop)
6
N.C.
7
N.C
8
N.C.
9
Ground, shield
4.5.2 Mo tor conne c t o r (X1, X2 ,Y, Z)
Fig. 15: Belegung Motorstecker Sub-D
Pin Nr.
Signal
1+6
Motor winding A +
2+7
Motor winding A-
3+8
Motor winding B +
4+9
Motor winding B-
5
Ground, shield