CNC-Step S-400 T - Install Worktop; Installation; Connecting the Computer

Operating Instructions
High-Z T-Series
CNC-STEP GmbH & Co. KG ▪ Siemensstrasse 13-15 ▪ 47608 Geldern ▪ Germany
Page 50
Support: +49 (0)2831/91021-50
15.02.2014
6.2.2 Ins t a ll w or ktop
The worktop (not included) may be as following, according to mounting maximum dimensions.
Fig. 22: Clamping range
Modell HIGH-Z
Dimensions of the worktop in
frame
S-400T
670 x 390mm
S-720T
990 x 510mm
S-1000T
1270 x 690mm
Modell HIGH-Z
Dimensions of the worktop on
frame
S-400T
790 x 390mm
S-720T
1110 x 510mm
S-1000T
1390 x 690mm
Fixing the worktop is done by yourself. As a recommendation, grooves in the frame of the
aluminium profile in conjunction with matching T-nuts (8mm groove width) can be supplied.
6.3 Installation
6.3.1 Conn e ct i ng t h e comp ut e r
HINT:
The connection of the PC / computer to the stepper motor is controlled according to
the information belonging to the stepper motor controller manual.