CNC-Step S-400 T - Operation; Safety Guidelines for Operation; Operations before Usage; Switching on

Operating Instructions
High-Z T-Series
CNC-STEP GmbH & Co. KG ▪ Siemensstrasse 13-15 ▪ 47608 Geldern ▪ Germany
Page 54
Support: +49 (0)2831/91021-50
15.02.2014
7 Opera tion
7.1 Safety guidelines for operation
Improper operation
WARNING:
Risk of injury by improper operation!
Improper operation can result in serious injuries and significant property damage.
• Perform all operations in accordance with the information and instructions of
this manual. Note the following before beginning work:
➢ Make sure that all covers and safety devices are installed and
working properly.
➢ Ensure that there are no persons in the danger zone.
• Never bridge or disable safety devices during operation.
7.2 Operations before usage
1
Make sure that all covers are installed on the machine.
2
Ensure the tightness of all connections.
3
Make sure that none of the emergency stop switch is pressed.
4
Check the ambient temperature.
HINT:
The individual materials have different coefficients of expansion. At an ambient
temperature of 20-25 ° C it is ensured that no significant impacts occur during
processing. Therefore, it is recommended to maintain an ambient temperature of 20-
25 ° C when operating the machine.
7.3 Switching on
Personnel:
Operator
1
Turn on the computer and boot the software.
2
Clamp work piece