CNC-Step S-400 T - Description of Process for Aligning the Machine with Respect to Perpendicularity; Commissioning after Fault Has Been Rectified

Operating Instructions
High-Z T-Series
CNC-STEP GmbH & Co. KG ▪ Siemensstrasse 13-15 ▪ 47608 Geldern ▪ Germany
Page 75
Support: +49 (0)2831/91021-50
15.02.2014
9.3.3 Desc ri pt i on o f p roc e s s for a l igning the mac hine w ith
res p e c t to pe rpen d i cu l ari t y.
Requirements: A complete structure of the portal system, including controller, PC and
software.
Using the control software of the machine (X-axis) drive against the movable bearing brackets of
the X-axis (see chapter 4.1) by manual, slow speed and stop for a short time(max. 5 mm / s).
Thereby the two stepper motor drives of the X-axis are synchronized, and the Y-bridge with the X-
axis is aligned at right angles. After this procedure, retract the Y-Bridge by about 30mm from the
stop blocks (depending on the position of the magnet holder of the X-axis) and then initiate a
reference run. The machine is ready for operation.
HINT:
Property damage caused by non-observance of perpendicularity!
Ignoring the perpendicularity can cause considerable damage to the mechanics.
HINT:
If in doubt please contact the customer service "customer service" on page 7.
9.4 Commissioning after fault has been rectified
Perform the following steps to restart after correcting the fault:
1
Reset the emergency stop devices.
2
Acknowledge the fault of the control.
3
Make sure, that nobody is sure no persons in the danger zone.
4
Start according to the instructions in chapter "Operation".