CNC-STEP GmbH & Co. KG ▪ Siemensstrasse 13-15 ▪ 47608 Geldern ▪ Germany
Support: +49 (0)2831/91021-50
9 Failures
In the following chapter possible causes of interference are described and how to solve them.
With increasingly occurring disorder shorten the maintenance intervals according to the actual load.
For malfunctions that cannot be remedied by the following instructions, contact the manufacturer.
9.1 Cautions for Troubleshooting
Electrical System
DANGER:
Danger to life due to electric current!
Contact with live components can be fatal. Activated electrical components can run
uncontrolled movements and cause serious injury.
• Before starting work, switch off electrical supply and secure against
reconnection.
WARNING:
Danger of injury by moving parts!
Rotating and / or linearly moving parts can cause severe injury.
• Before starting maintenance on movable components, turn off machine and
secure against reconnection. Wait until all parts have come to a standstill.
• In hazardous area wear tight-fitting protective clothing with low tensile
strength
To Next Page
Loading...
