CNC-Step S-400 T - Page 71

Operating Instructions
High-Z T-Series
CNC-STEP GmbH & Co. KG ▪ Siemensstrasse 13-15 ▪ 47608 Geldern ▪ Germany
Page 71
Support: +49 (0)2831/91021-50
15.02.2014
Improperly executed fault elimination
WARNING:
Risk of injuries caused by improper fault elimination!
Improperly performed work and troubleshooting can cause serious injury and
considerable damage to property.
• Before starting any work sufficient installation freedom has to be given
• Maintain order and cleanliness at the installation site! Loosely stacked or
scattered components and tools are accident sources.
• • If components have been removed, ensure correct assembly, reinstall all
fasteners and tighten with screw tightening torques.
Note the following before restarting:
➢ Ensure that all work and troubleshooting according to the information and
instructions in this manual have been carried out and completed.
➢ Ensure that there are no persons in the danger zone.
➢ Ensure that all covers and safety devices are installed and working
properly.
Response to malfunctions
1
For malfunctions that constitute an immediate danger to persons or property, immediately
initiate emergency stop
2
Determine cause of malfunction.
3
If the troubleshooting requires work in the danger area, turn off the machine and secure against
reconnection. Inform responsible about disorder immediately
4
Depending on the type of disorder this can be eliminated by authorized personnel.
The fault table listed below provides information about who is entitled to eliminate
the fault.