CNC-Step S-400 T - Page 46

Operating Instructions
High-Z T-Series
CNC-STEP GmbH & Co. KG ▪ Siemensstrasse 13-15 ▪ 47608 Geldern ▪ Germany
Page 46
Support: +49 (0)2831/91021-50
15.02.2014
Slinging
Protective-Equipment / Industrial safety helmet
Fig. 20: lifting gear
1
Sling on ropes, belts accordingly (Fig. 20) to the pallet and
secure pallet against slipping.
2
Check whether the transport pieces are not damaged by the
slinging materials. If necessary, use other slings.
3
Make sure that the pallet with off-centre gravity cannot tip.
4
Start the transport.
Transport of pallets with a forklift
Transport pieces, which are attached to pallets can be transported under the following conditions
using a forklift:
• The fork lift must be rated for the weight of the transport pieces.
• The transport package shall be securely fastened on the pallet.
• The folk lift driver must be authorized to drive industrial trucks with driver's seat or driver's
cab according to national regulations.
Transport
Fig. 21: Transportation by forklift
1
Drive the forklift with the forks between or the holms of the
pallet.
2
Drive the forks so far that they protrude on the opposite side.
3
Make sure that the pallet with off-centre gravity cannot tilt.
4
Lift the pallet with transport piece and start the transport.