CNET CSH-2402S - Power Connection; LED Description; Figure 2-6 Rear Panel; Table 2-3 LED

Smart Ethernet Switch Series User’s Manual
Do NOT connect a telecommunication cable to the fiber port.
To avoid risk of severe eye damage, do NOT look into an operating fiber port
and/or fiber connector.
2.4.2. Power Connection
The power socket is located on the rear panel of the switch. Use the power cord to connect
this socket to a power source to power on the switch.
Use the power source as labeled on the rear panel.
Figure 2-6 Rear Panel
2.5. LED Description
The following table describes the LEDs on the front panel.
Table 2-3 LED
LED STATUS DESCRIPTION
PWR On The smart switch is receiving power.
Off The smart switch is not receiving power.
LNK/ACT On The port is connected and is transmitting data.
Blinking The port is connected and is transmitting data.
Off The port is not connected.
12