Smart Ethernet Switch Series User’s Manual
Table 5-2 Switch Status: MIB Information
LABEL DESCRIPTION
RX Counter This field displays the amount of traffic received on the port.
RX Unit This field displays the traffic unit on the port.
TX Counter This field displays the amount of traffic transmitted on the port.
TX Unit This field displays the traffic unit on the port.
Diag. Counter This field displays the total amount of traffic received/transmitted on the port.
Diag. Unit This field displays the traffic unit on the port.
Start Click Start to start counting the traffic through the ports. The information is
automatically updated in this screen.
Stop Click Stop to stop counting the traffic through the ports. You must click Start
again to update the information in this screen.
Clear Click Clear to reset the counters.
Pause/Continue Click Pause to stop counting the traffic through the ports.
Click Continue to resume the counter update.
5.2.1. Changing the Counter Unit
To change the counter unit, right-click the mouse in the MIB Information list table.
The following table shows the options you can select.
Table 5-3 Switch Status: MIB Information
COUNTER UNIT OPTION
Byte Per Byte
Per KByte
Per MByte
Per GByte
Packet
CRC Error Packet
Collision Packet
5.3. Cable Tester
You can test port connection in the Cable Tester screen. This allows you to diagnose the port
cable links and determine possible connection problems.
Click Switch Status > Cable Tester to display the screen. Click Start Testing to begin the
test.
27
To Next Page
Loading...
